I

Magnetic Gutter system for the Modular Hextraction Board

by
Inaudable
Follow
Follow
Remix Model
I
Inaudable
|
Image 1 of 3
Magnetic Gutter system for the Modular Hextraction Board 3d model
I
Inaudable
|
Image 1 of 3
Magnetic Gutter system for the Modular Hextraction Board 3d model
2D
3D
Makes
Magnetic Gutter system for the Modular Hextraction Board 3d model
Magnetic Gutter system for the Modular Hextraction Board 3d model
Magnetic Gutter system for the Modular Hextraction Board 3d model

Magnetic Gutter system for the Modular Hextraction Board.

This is an easier to use gutter system than the original Modular Hextraction Board, however it requires magnets.

They are designed to work with 12mm x 3mm round magnets. (It may work with slightly smaller or larger magnets, but if too small they will not be strong enough to stop the ball.) As seen in the photos you really only need one magnet on the lower of each pair of gutters.

Print Settings: Best printed in its current orientation. As with the original join + to - pieces. So - for right hand side of board and + for left.

I printed everything with PLA+ with 3 perimeters, 0.2mm layer height. 20% infill, 5 top and bottom layers.

-- Thanks:

If you're feeling generous my Paypal donation link is below, and will be used to buy more filament. Anything would be greatly appreciated!

Paypal Link

Thanks to Zack and his original design of the Hextraciton board game it’s heaps of fun!


10 Likes39 DownloadsMay 27, 2024
1


10 Likes39 DownloadsMay 27, 2024